OUR ONLINE CHECKOUT is CLOSED and we are NOT accepting any NEW orders at this time.

We are still fulfilling and shipping previously submitted and/or delayed order requests (as product availability allows) UNTIL NOVEMBER 15th 2022.

But after November 15th, all still pending backordered unshipped items will be automatically CANCELLED **(except for any special ordered drop-shipped or made/machined-to-order items).

Our ability to respond to emails is greatly hampered by being under-staffed during this downsize transition time. But we continue to endeavor to answer email inquiries as best we can. And we will continue responding to emails through until early March 2023 because we are wholly committed to resolving any other issues that may arise from previous sales. It is still UNCERTAIN, but we may re-open a substantially downsized version of our store again in the Spring of 2023.

We sincerely appreciate your patience, understanding during this period of restructuring and/or closing. And a huge thank you to all of you whose support and loyalty we have been the beneficiary of over the 23 years that we have worked diligently to support the information and parts needs of the aircooled VW community!


  VW Parts Catalog > Engine Parts >

Hardened Lash Caps for 8mm and 9mm Valves, Set of 8
Hardened Lash Caps for 8mm and 9mm Valves, Set of 8


 
These are small steel "hats" that fit on the end of the valve, and these wear out instead of your valve. A good idea if you have a bigger cam than stock, ratio rockers, OR stainless valves! These caps add around .060" to the valve height. This is a set of 8 to do one engine.

It's important to note that you use lash caps OR swivel feet/Elephant's Feet/911 Adjusters, you never use both! Lash caps are used with Scuffer Tip Rockers (rockers that have the adjusting screw on the pushrod end), or when using non-swivel type valve adjusting screws. Consider Lash Caps as replaceable items as they wear out, they are cheap.

Some people say that lash caps "must fit tight on the valve", but we disagree. It should be a snug, but not tight, fit. A little float is not going to kill you! It's not uncommon for lash caps which are "snug" to be a BEAR to get back off again, as the valve end deforms and swells inside the lash cap. This then requires a special puller to remove the cap!

Price: $12.95


: LASH-CAPS-8MM


QTY:
Overview
 
These are small steel "hats" that fit on the end of the valve, and these wear out instead of your valve. A good idea if you have a bigger cam than stock, ratio rockers, OR stainless valves! These caps add around .060" to the valve height. This is a set of 8 to do one engine.
Average Customer Review: Average Customer Review: 4 of 5 4 of 5 Total Reviews: 1 Add your review too!

Related Items...
SCAT Swivel Ball Style Valve Adjusters (Courier Adjusting Screws), Set of 8, 20118
Price: $34.95
SCAT Swivel Ball Style Valve Adjusters (Courier Adjusting Screws), Set of 8, 20118


  2 of 2 people found the following review helpful:
 
4 of 5 Snug fit, good quality, easy to install. December 26, 2012
Reviewer: Jose Marquez from Covina, CA United States  
As it says in the product description, they fit snug on my L5ACN heads. They were perfect to help make my valve geometery spot on. The only reason I didn't put 5 stars is because this was my first engine build and haven't had experience with other caps and because I hadn't measured the thickness of any of them to verify consistency.

Was this review helpful to you?