We are in the midst of renovating our site!

Our online store will re-open on WEDNESDAY AUGUST 12th with some exciting updates and improvements to your parts shopping experience.

If you already have an order in process with us, don't panic!

We are still processing and shipping orders from our warehouse as normal even while our site is offline.

We sincerely appreciate your patience while we are doing these site upgrades.


  VW Parts Catalog > Engine Parts >

6 MM Stud Conversion Kit for Oil Pumps, 3036-10
6 MM Stud Conversion Kit for Oil Pumps, 3036-10


 
6 MM Stud Conversion Kit for Oil Pumps, 3036-10 helps you install the 8mm stud oil pumps into your 6mm studded case that you are using. Using this kit prevents leaks and problems, and is needed because new 6mm stud pumps are no longer available! ACN recommends that you use a 21mm pump in any single relief case application.

The stud spacing on the 6mm studded cases is slightly different than the 8mm version. If they were the same you could just drill and tap the holes to 8mm, and use an 8mm studded pump, and bolt it together. But it's not that simple. That's also why you cannot simply use a "step stud" with a 6mm case end, and 8mm pump end. So this kit includes 4 long studs, nuts, and washers. You put the studs in, and thread them so they protrude in the case enough to get the nuts on the inside. Use loctite, and tighten the nuts against the case, with no stud sticking further than the top of the nut. Now the pump nuts on the outside can be tightened without the risk of the stud stripping the case threads, since it's backed by a steel nut on the inside!
Price: $6.95

: 3036-10


QTY:
Overview
 
6 MM Stud Conversion Kit for Oil Pumps, 3036-10 helps you install the 8mm stud oil pumps into your 6mm studded case that you are using. Using this kit prevents leaks and problems, and is needed because new 6mm stud pumps are no longer available! ACN recommends that you use a 21mm pump in any single relief case application.

The stud spacing on the 6mm studded cases is slightly different than the 8mm version. If they were the same you could just drill and tap the holes to 8mm, and use an 8mm studded pump, and bolt it together. But it's not that simple. That's also why you cannot simply use a "step stud" with a 6mm case end, and 8mm pump end. So this kit includes 4 long studs, nuts, and washers. You put the studs in, and thread them so they protrude in the case enough to get the nuts on the inside. Use loctite, and tighten the nuts against the case, with no stud sticking further than the top of the nut. Now the pump nuts on the outside can be tightened without the risk of the stud stripping the case threads, since it's backed by a steel nut on the inside!

Share your thoughts on this product with other customers...
Click here to be the first to WRITE A PRODUCT REVIEW!